Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
VAG CAN PRO 5.5.1 clone help
27-06-2019, 10:25 AM,
Post: #11
|
|||
|
|||
RE: VAG CAN PRO 5.5.1 clone help
will make pictures today and send it to you as soon as possible
|
|||
27-06-2019, 18:17 PM,
Post: #12
|
|||
|
|||
RE: VAG CAN PRO 5.5.1 clone help
here are pictures of my VCP... at this point all works
|
|||
27-06-2019, 18:26 PM,
Post: #13
|
|||
|
|||
RE: VAG CAN PRO 5.5.1 clone help
|
|||
28-06-2019, 05:01 AM,
(This post was last modified: 28-06-2019, 05:20 AM by podlbo.)
Post: #14
|
|||
|
|||
RE: VAG CAN PRO 5.5.1 clone help
i did resolder ALL of pins connecting the PCB again - becouse in one case there wase bad/cold solder. Plus on the back of my PCB there was 2 pins soldered together (i did remove excess solder) by mistake. I did circle problematic areas on my VCP - pins connecting connector where compleatly resoldered + pins for connecting usb cable. Please you need to know not all of 16 pins from connector are connected/wired to PCB (this is normal).
|
|||
28-06-2019, 06:02 AM,
Post: #15
|
|||
|
|||
RE: VAG CAN PRO 5.5.1 clone help
(28-06-2019, 05:01 AM)podlbo Wrote: i did resolder ALL of pins connecting the PCB again - becouse in one case there wase bad/cold solder. Plus on the back of my PCB there was 2 pins soldered together (i did remove excess solder) by mistake. I did circle problematic areas on my VCP - pins connecting connector where compleatly resoldered + pins for connecting usb cable. Please you need to know not all of 16 pins from connector are connected/wired to PCB (this is normal). hi podlbo, i know i don't need all 16 pins soldered but i soldered em any way, i also had two pins soldered together, the k line and the l line, so i removed the bridge, still no connection, i'm gonna call it a day, it must be a dud cable somehow, i'll pick up another one, i can't be that unlucky to get two bad cables in a row, lol, goodluck podlbo, thanks for all your help. |
|||
28-06-2019, 06:18 AM,
(This post was last modified: 28-06-2019, 07:32 AM by Clusters.)
Post: #16
|
|||
|
|||
RE: VAG CAN PRO 5.5.1 clone help
you can check also if USB cable is OK (if i remember i also have slightly pinched red cable by VCP cover plastic - no big deal) .... So all the wires are actualy OK.
at the end, if all falls down you can tray to "oven metod" Put your pcb in heated oven (200 deg) for 8-10 min -> cool it down -> test In worst you will "fry" your VCP, and in best all will start to work |