Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
CANBUS emulator for bench test
20-08-2019, 12:44 PM,
Post: #11
|
|||
|
|||
RE: CANBUS emulator for bench test
hello...do somebody post here arduino scretch for can shield to start NBT ?
BR |
|||
20-08-2019, 16:59 PM,
Post: #12
|
|||
|
|||
RE: CANBUS emulator for bench test
(20-08-2019, 12:06 PM)DayvG Wrote: Thanks mate, much appreciated. I have a Pi that I use as a games emulator, I’ll have to try and work this out. Looking at that board, does the USB attach to the Pi? And the pins connect to setup? I’ve looked at the schematic and can’t work it out just yet. Looks like it’s time to start researching No USB shield use SPI. You can use dupont wire to connect shield. I have attached a new link with better pictures check it out. There is more than one way to do the hack basic solder skills are enough to do it. Or you buy a compatible shield for raspberry pi (3,3 V GPIO) then no solder necessary. If you have problems with hack poste and I try to help you. |