[chanky]

Hi
i wanted yesterday retrofit a Entry NAV to NBT HU,
My problems starts with wrong CASE from CID HIGH. because my EVO ist from F20 and i wanted retrofit it in F34.
Problem solved, Change only back case from CID HIGH.

After that my original CID wire was not correct, i have to change it.

This was correct for 609: 61129399972

After that i think now its all ok  

I code the NBT with new FA. all was ready BT, AUDI BT, i wanted now start with Activation Navigation with FSC.
And now starts problem. USB doent read the Stick

After a moment i get a USB with LED, no led was on.
If i use a USB i get on Tool32 error

Code:

0xB7F8AF   USB-VBUS Verbindung Head-Unit zur USB Benutzer Schnittstelle: Kurzschluss nach Masse

   Testbedingungen erfüllt
   Fehler momentan vorhanden und bereits gespeichert
   Fehler würde kein Aufleuchten einer Warnlampe verursachen
   Dies ist kein Ereignis-DTC. Das SG ist für den Fehlerspeichereintrag (DTC) verantwortlich.

Maybe someone have the same problem? Or can help me?

[bmwcoder75]

Short circuit fault apparently

[duckdonald]

if you are using the original HU-ENTRY cable, to connect it to HU professional it must be rotated 180 degrees.

[chanky]

if you are using the original HU-ENTRY cable, to connect it to HU professional it must be rotated 180 degrees.

do you mean this?

[jaramillo]

Thats right, after shaving the edges you should rotate the plug

[chanky]

Thats right, after shaving the edges you should rotate the plug

Keep this without the assurance???