[Matthew53]

I tried to do the calculation in the "Construction Progress" mode and I have to admit that it worked, but all blue lines (picture in the attachment). In the next steps also different than it should be. Does this mean that the ECU are updated to the highest available version?
A few weeks ago I was doing programming with CGDI. Is it possible to upload the latest dates?
I still have a DDE from this bench that I did not program with CGDI. I will connect it to the bench and see how it will look like then.
To make sure that I am doing everything correctly, I used a different bench
FEM + platform and everything went fine there. After the calculation, there were blue and red lines. The programming was positive. However, I have another question, namely after programming this FEM Esys still shows the old I-Step. Do you have to uncheck something in the settings? do I always have to manually change the current I-Step? Thanks in advance for the hints.
a lot of learning awaits me with this program

If you set update VCM in Esys options, then it will update I-step after programming.

[Cowboy]

For calculating flash use Read VO > Read ECU > tick "complete flash" > set iStep (shipm) to build ilevel, than press calculate.

Calculation in the "Construction Progress" only work with launcher esysx, not with esys alone.

Which of the tools currently available on the market, e.g. BU, Esys ultra, etc. includes "Construction Progress"? Thank you in advance for the hint and best regards.

[user_530d]

Esys Ultra has "SVT Construction Preview".

[Cowboy]

Hello! Can someone tell me if for the F series you can check the following information in PSdZ files: update history for the ECU as in the E series? Thank you in advance for the hints and best regards!