[whom1]

Hello Dr.Gini,
many thanks for the answer. I had connected ENET cable. So it only works with an ICOM or emulator !?
greeting
Waldi

Hi whom1,
please see the first post
http://cartechnology.co.uk/showthread.ph...4#pid72494

"...This diagnostic software requires Ediabas properly installed and functional with a communication interface ( ICOM, ENET or K+DCAN ) ..."

For ENET interface, you have to set in C:\EDIABAS\Bin\EDIABAS.INI

[Configuration]
Interface = ENET

Hello Dr.

it was my mistake, have the wrong path. Everything works fine.

Many Thanks!

Waldi

[teckno88]

How do you setup the interface for KDCAN?

[Gini]

How do you setup the interface for KDCAN?

Hi teckno88,
For K+DCAN interface, you have to set in C:\EDIABAS\Bin\EDIABAS.INI

[Configuration]
Interface = STD:OBD

[teckno88]

Hi I already have Ediabas file from other programs so I would assume I need to either edit the file or add the line interface = STD:OBD.

Do I need to have car plugged in for it to work?

Error; 126(Ediabas) -api-0006:Access to runtime system not possible

Got it working just copied the installed files over to Ediabas folder and sent launcher to desktop.

[whom1]

Had such an error; 126 (Ediabas) API 0006 with me the path was not properly held c / it has been installed in path d /. Delete the program and intstallend it new and eighth on the path C /

[ipcsr76]

Gini, Great work! I noticed a couple of issues.
1. Gauges do not work on my E90 N54 even if I select Benzin.
2. It does not calculate maps FSC for App-Nr 2D (North America Premium). I click on Get Code and nothing happens. Telegram button is also disabled.

dbond, PM sent

---

EDIABAS configuration for ICOM interface

1. iToolRadar
+Connect the ICOM interface to the car and to the PC
+Run iToolRadar and wait a minute until your ICOM appears in the Active Services table
+Select the first line and press the Reserve button
=Device State should change from Free(green) to Reserved(Red)
=Report the IP address to RemoteHost in EDIABAS.INI (eg. 169.254.92.38)

2. C:\EDIABAS\Bin\EDIABAS.INI
make sure your configuration is as follows. Use the Search function from your Text editor to avoid duplicate parameters
Note:
Semicolon before a parameter = parameter deactivated

[Configuration]
Interface = REMOTE
;Interface = ENET
;Interface = STD:OBD
Simulation = 0

NetworkProtocol = TCP

[TCP]
RemoteHost = 169.254.92.38
Port = 6801
Port = 6802
TimeoutConnect = 2000
TimeoutReceive = 2000
TimeoutFunction = 10000

3. Run Dr.Gini

OK

THANKS A LOT

I tried this config and i send feed back.

Cool

[sergis]

At me doesn't work with icom.Help

[Thriller]

Guys,
why don't you use easyconnect? Just select your interface in the combo and push a button

STD for Dcan (mode obd)
Remote for ICOM (mode base or most_ctrl_ab625 in case of flashing CIC)
Enet for enet interface or lan to USB adapter

http://cartechnology.co.uk/showthread.ph...asyconnect

[Gini]

At me doesn't work with icom.Help

Hi sergis,
give me access to your PC via Teamviewer

[cupra80]

Everything works fine! Thanks!