[Fps]

Hello!
Having troubles with bench connection. When I turn on power supply, kombi flickers for 1 sec. and turn off lights. When I put the blank key I get image that key is not recognised. Is it right how it should work?

[Cowboy]

what's your cas with or without ELV? if with ELV then you need an emulator. It looks as if there was no wake-up for KL15
I watched the movie again, you have CAS 2 connected, so you need an ELV emulator

[Fps]

what's your cas with or without ELV? if with ELV then you need an emulator. It looks as if there was no wake-up for KL15
I watched the movie again, you have CAS 2 connected, so you need an ELV emulator

The Cas2 is from e60 I think it shouldn't have ELV. Is it necessary to connect ELV emulator?

[Cowboy]

Each CAS2 is with ELV, you must use an emulator

[flamurfetahu]

can i use only CAS3 from an E90 LCi,i need only for flashing units on bench !

[Spitfire555]

can i use only CAS3 from an E90 LCi,i need only for flashing units on bench !

For flashing units on bench you need gateway. The CAS is no gateway. CAS is mostly used to get a valid ignition ON signal on the bus.

So finally .... "No", only CAS not working for updating units on bench.

[johann74270]

Hello! I am in the process of connecting modules on the table and I noticed that my CAS and JBBFE II modules do not have a PIN 40 output. I do not know what to do. Can I add these pins myself? Thanks in advance for tips and greet

Hello 
Me too, I don't Have pin 40 
Have you find a issue?

[johann74270]

finished making my harness clean and simple. using all oem connectors, i can make cas2/3 keys, read DME ISN, test keys, test kombi

tested with CGDI and MULTI TOOL, INPA, ISTA, NCSEXPERT. works good, and makes making keys a whole lot easier on bench. made a few keys already, im using with a ELV emulator for CAS that require elv and had no issues, also downgraded CAS with cgdi no issues so far.




reading dme

using elv emulator

hello can you tell me where I should put the CAN bus resistors please?

[Trickd122]

finished making my harness clean and simple. using all oem connectors, i can make cas2/3 keys, read DME ISN, test keys, test kombi

tested with CGDI and MULTI TOOL, INPA, ISTA, NCSEXPERT. works good, and makes making keys a whole lot easier on bench. made a few keys already, im using with a ELV emulator for CAS that require elv and had no issues, also downgraded CAS with cgdi no issues so far.




reading dme

using elv emulator

hello can you tell me where I should put the CAN bus resistors please?

Hello Can you share with me the wiring harness setup and pin out? I have a harness from an F10 that I can use along with a KOMBI  ZGW CAS3 JBBE FRM modules from the same car. I would really appreciate your help.

[pedroSR]

Hello everybody,

Please, where I can buy those OEM connectors to build the Cniksor setup?

Many thanks!!!