[winter]

I know that flashing NBT with ENET and Esys works.

But I wanna try to flash with ISTA/P like the BMW Dealer does it.

For the DHCP Server, does it mean I have to connect the ENET Cable to a router and the Computer too?

Gesendet von meinem Nexus 5X mit Tapatalk

http://cartechnology.co.uk/showthread.ph...#pid147928

I posted the solution literally two posts above your original post. You don't need a router, but you do need a DHCP server on the ethernet interface on your laptop.

The problem is that either the ENET or ICOM interface doesn't get an IP to start programming when those modules are flipped into boot loader mode. So they basically time out and abort programming.

DHCP Server works the same with ENET or ICOM, it'll hand out IP addresses to all the devices connected to the Ethernet port and inside the vehicle.

Dear dracon:

You said "DHCP Server works the same with ENET or ICOM",could you program MOST modules by ENET cable +DHCP server?I was sure ICOM+DHCP server totally support MOST programming,but for ENET cable couldn't recongnize the VIN.

If you said ENET+DHCP server is valid for MOST programming,How to setup?is it same with ICOM?please give me detailed information.thx a lot!