[Mwahab]

Hello!

I know many in here need to set up their, one of the easy ways is using FEM_BODY
it will be as follows.

+12V
Ground
CAN Signals
Ethernet from FEM to HU (OABR) for EVO
Ethernet from FEM to RJ (PC)

FEM Section

+12v to PIN 33 in black connector A173*3B


Ground to PIN 33 in White connector A173*4B

Remember to make bridge and leave it, we will get to this point later in here.


Now Ethernet cable from FEM to PC.

A73*8B
As the diagram showing



I will write it in details later.

Now Your FEM is connected and can be read in Esys.

Headunit section

For +12v its on Pin 15
Ground PIN 12

Ethernet, in NBT EVO is through OABR

and here is it

From the small port on FEM to OABR

--
All what is left is CAN signals.

A73*8B on FEM
PIN 49 - 50 to HU
Yellow/brown PIN 49
Yellow/red PIN 50
HU at PIN CAN L 9 - CAN H 11
FEM A73*8B


To be continued.