Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
E46 2002 + icom + no communication
16-12-2018, 13:59 PM,
(This post was last modified: 16-12-2018, 14:02 PM by Clusters.)
Post: #1
|
|||
|
|||
E46 2002 + icom + no communication
Hi,
I try to connect to E46 2002 year with icom. In ista i get: "The vehicle could not be identified. Please check the access to the vehicle and check whether the testing-analysis-diagnosis has been activated" In Inpa IFH-0010 error on every module. It's icom so no need manipulate pin 7 and 8. Mayby ediabas? I have installed only patched - 7.3. I shoud try with 2.12? If I helped, please magic buttons thx+rep
|
|||
16-12-2018, 14:17 PM,
(This post was last modified: 16-12-2018, 14:27 PM by Twoone.)
Post: #2
|
|||
|
|||
RE: E46 2002 + icom + no communication
(16-12-2018, 13:59 PM)lustek Wrote: Hi,No need to do something with PIN 7 and PIN 8 On Inpa with ICOM are the dots for KL30 and KL15 black? Could be problem of the ICOM not detect KL15. Check also power on pin 16 on OBD of the car, and when ignition is ON also pin 1) If you use ISTA you select ICOM/ENET in VCI, ediabas patched is not used.(Directly from ISTA to LAN adapter) Are u using ITOOL radar or Easyconnect to reserve ICOM when working with INPA? Does ICOM shows up in connection manager of ISTA ? |
|||
16-12-2018, 15:00 PM,
Post: #3
|
|||
|
|||
RE: E46 2002 + icom + no communication
Hi,
Yes everything is OK. I use that icom many times. In ISTA kl15 and kl30 voltage is showing OK so pin 16 and 1 OK. In Inpa 2 black dots. I try to reserve icom in itoolradar and easyconnect. I install ediabas from standard tool 2.12, configure it by bmw coding tool but no communication. What voltage should be on pin 8 and 4/5? If I helped, please magic buttons thx+rep
|
|||
16-12-2018, 15:07 PM,
Post: #4
|
|||
|
|||
RE: E46 2002 + icom + no communication
45 is the GND 8 is the K-line with about ~12V!
|
|||
16-12-2018, 15:11 PM,
Post: #5
|
|||
|
|||
RE: E46 2002 + icom + no communication
(16-12-2018, 15:00 PM)lustek Wrote: Hi,Pins 4/5 are ground Pin 8 is K-Line signal and you cannot measure with DVOM because DVOM measures RMS voltage. You have to use Occiloscoop. |
|||
16-12-2018, 15:25 PM,
Post: #6
|
|||
|
|||
RE: E46 2002 + icom + no communication
4/5 is ground i know.
So I can't put multimeter one leg in 4/5 pin and second in 8 and meansure voltage or resistance?I dont have osciloscop. If I helped, please magic buttons thx+rep
|
|||
16-12-2018, 16:11 PM,
(This post was last modified: 16-12-2018, 16:33 PM by Twoone.)
Post: #7
|
|||
|
|||
RE: E46 2002 + icom + no communication
(16-12-2018, 15:25 PM)lustek Wrote: 4/5 is ground i know. You can measure a voltage on the k-line and signal gnd on pin 5 that way but it dus not say anything about the quality of the data signal. Normaly K-line idles high, with a 510 ohm resistor to Vbatt |
|||
16-12-2018, 16:37 PM,
Post: #8
|
|||
|
|||
RE: E46 2002 + icom + no communication
(16-12-2018, 13:59 PM)lustek Wrote: Hi, check if the IP address in Ediabas .ini is the same as the one you see in iTool Radar. |
|||
16-12-2018, 17:18 PM,
(This post was last modified: 16-12-2018, 17:22 PM by lustek.)
Post: #9
|
|||
|
|||
RE: E46 2002 + icom + no communication
I configure ediabas to work as remote. Ip address is in remote.ini. i check them and is OK.
What I can do else? Tomorrow i will check fuses. If any module is faulty, they can block k-line and diagnostic? If I helped, please magic buttons thx+rep
|
|||
16-12-2018, 17:25 PM,
Post: #10
|
|||
|
|||
RE: E46 2002 + icom + no communication
Is there anything retrofitted to the car that could interrupt the Kbus? You could try any disconnecting one pin at a time for the kbus connection under the right side of the dashboard behind the glovebox to outrule any interruptions there.
- Remote coding & programming - F 8HP45/50/70/75 ISN reset remote
- Remote ECU tuning MEVD17 + EDC17 + MGD1 ECUS + 8HP EGS BMW/MINI - M2/M3/M4 CS, CSL OR GTS Flash F8x G8x - 8HP Alpina EGS flash F & G remote - EVO ID4 to ID6 flash - Apple Carplay activation Skype: live:fatalix - Whatsapp: PM for details |
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Return to TopReturn to Content