[_estima_]

Good afternoon friends
I have a BMW F11 520D in my workshop to repair . Had a eletrical problem, then
I changed the DDE , DASH , FRM , CAS , ZGW , and other modules . I bought another F11 modules used .
I have ICOM A2 and ISTA / D and ISTA / P . When I try to encode or program , tells me that I have to dismantle and replace the units .
Someone with experience who can help me ?

excuse my English.

[_estima_]

I need to change VIN in units?

How can i programe the used modules ?

help me .


thanks for all

_estima_

[SweetBMW]

Program vin in the used units with esys. then program + code with ista p

[_estima_]

I will try and send feedback

[9a10qr]

Program vin in the used units with esys. then program + code with ista p

this way impossible mate,
not enough only change vin number on dme, cas and egs.
should change dme and cas vin first on desk with programmer,
then you should extract isn from old modules and write on cas dme and egs
then you can program with e-sys.

[_estima_]

Hello 9a10qr

if i read DME with new trasdata , i can change the VIN in unit?
My CAS is NEW and the VIN is right now , and i change the VIN in KOMBI also. I have newbie in the e-sys software, i need help to extract
isn from old modules .

thanks for your help

[SweetBMW]

Ah sorry, i read too quickly, didnt see it was the DDE and related units... sorry.

[_estima_]

Ok , no problem ...

[_estima_]

Hello

hi try to code FRM , but when hi read SWE , appear a lot of CAFD files .
What file hi choose to program? im newbie in this software.
sorry for my ignorance.

[_estima_]

Its possible to read CAFD files to original modules and write in used modules ?
sorry if my question dont make any sence.