Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
Icom Next A issue
21-04-2022, 20:10 PM,
Post: #1
|
|||
|
|||
Icom Next A issue
Hello, I have an ICOM NEXT original that can't read E83 3.0d '06, why is this due to the fact that there is no support for the K line? I used to have an ICOM A2 clone and I never had to build a bridge between 7 and 8 pins and now ICOM NEXT did not want to read any module and did not identify the car at all until I made a 7 and 8 pin bridge.
Do you have any idea why this is so? The firmware of ICOM NEX is FW_03-15-08 ISTA Standalone 4.34.4x Any help will be helpful. |
|||
21-04-2022, 20:18 PM,
Post: #2
|
|||
|
|||
RE: Icom Next A issue
Can you post picture from itoolradar fw next
|
|||
21-04-2022, 20:26 PM,
Post: #3
|
|||
|
|||
RE: Icom Next A issue
(21-04-2022, 20:18 PM)Bimmer540 Wrote: Can you post picture from itoolradar fw next I can, but tomorrow it will be too late to go down to the garage again. |
|||
21-04-2022, 20:40 PM,
Post: #4
|
|||
|
|||
RE: Icom Next A issue
Try
BMW_ISPI_ICOM-FW_03-22-11.msi |
|||
21-04-2022, 21:17 PM,
Post: #5
|
|||
|
|||
RE: Icom Next A issue
ICOM Next should read all BMW cars. If it can't then either it's faulty or there is something wrong with a car.
|
|||
22-04-2022, 00:39 AM,
Post: #6
|
|||
|
|||
RE: Icom Next A issue
It is faulty, there is no switching on pin 8 and most likely one of the 393 is faulty
|
|||
22-04-2022, 10:44 AM,
Post: #7
|
|||
|
|||
RE: Icom Next A issue
(22-04-2022, 00:39 AM) ferrum Wrote: It is faulty, there is no switching on pin 8 and most likely one of the 393 is faulty Hi, I enclose a few screenshots and logs of the device, if anything more can be understood from them. The device test passes without error. If there is a defective element on the motherboard, I hope to replace it without additional conditions, it was purchased from a company distributor of OEM parts. |