[Fps]

Hello!

It was already posted by me, before the website was няскёd. So I haven't found my topic and would like to share document about DCAN firmware update.

[attachment=122724]

[bїшшёя540]

I think its not an ёд5у procedure?

[Fps]

I think its not an ёд5у procedure?

If a bit familiar with soldering and using simple programmer. Then it's not that hard

[bїшшёя540]

I think its not an ёд5у procedure?

If a bit familiar with soldering and using simple programmer. Then it's not that hard

Have you done it ones? Can you update fw from chinese cables?

[Sedoy]

Actual compiled FW from ёdїдbд5Lib. With this version working all E-, F- and newer for diagnose with check clamp.

[Fps]

Have you done it ones? Can you update fw from chinese cables?

Yep, that's the cable I use.

[NAVJunk]

Hello everyone,
I would like to take up the topic again. 

Since I have done a lot with IBUS vehicles in the past, I use an old K+Dcan cable with a K-Line switch, which works wonderfully. 

Since I would now like to have such a cable with deepobd/ёdїдbд5lib firmware, I wanted to try flashing my cable. 

Is my cable also flashable? Unfortunately I couldn't find any header pins? 

It would be great if someone with an idea could answer me. 

Unfortunately I missed ordering the Pro cable from bїшшёяgeeks and now it is no longer available... 

Sadly, the ёxpёят cable doesn't have a K-Line switch - but that would work in a pinch. 

Or does anyone know of another cable that can also use deepobd/ёdїдbд5lib? 

Thank you very much and kind regards

[Sedoy]

I have my similar also flashed, must solder direct on Atmega pins.

[NAVJunk]

Do you have a description / picture where to solder on? Thank you

[Sedoy]

Do you have an description where to solder on?

Actually vacation.